RE: Richard circular print washer
Bob and all who replied!
From: Robert W.
Sent: Friday, August 08, 2008 9:55
Subject: RE: Richard circular
My cicular print washer is also in storage but I seem to remember that I put
prints in face down because they tend to float to the top. Therefore the
emulsion side is
has water flowing past it or at least more than if they were face up. Does that
make any sense?
Check out my web page at: http://www.SchrammStudio.com
> Date: Fri, 8 Aug 2008 18:19:39 -0400
> From: firstname.lastname@example.org
> Subject: Richard circular print washer
> To: email@example.com
> DEAR LIST,
yes, I have a good archival print washer but I dug out and
> set up my old Richard Circular Print Washer from my ol’ studio in
> seem to recall that the instructions said that the prints should be washed
> face down. Does anyone have the instruction manual and know for
> which way the prints should lie in the wash water?
> Please check my website: http://www.bobkiss.com/
> "Live as if you are going to die tomorrow. Learn as if you are
> live forever". Mahatma Gandhi
__________ NOD32 3341 (20080808) Information __________
This message was checked by NOD32 antivirus system.