From: Judy Seigel (firstname.lastname@example.org)
Date: 10/25/02-08:28:24 PM Z
On Fri, 25 Oct 2002, Robert W. Schramm wrote:
> ....Judy told me to
> use a soft brush and swirl it around on the print while it was in the tray
> of developer. This works very well.
Brush development of lith film for continuous tone:
Use a wide soft brush or even a foam brush (I use an old outdated static
master) and go back and forth (not necessarily touching the film, above it
is OK -- which also disturbs the laminar layer). Speed of going first left
right, then front back covering area methodically controls your agitation.
Low or high.
This is covered in P-F, what.... #2?
PS. I got this from Barbara Crane, but other folks do it. No mottle.
This archive was generated by hypermail 2.1.5 : 11/14/02-02:40:27 PM Z CST