From: Sandy King (email@example.com)
Date: 08/07/03-12:30:20 PM Z
Just for the record, I do the alignment check on regular paper and
leave the paper setting thickness set to standard (0) for Pictorico.
However, Pictorico, at about.0065" thick, is almost twice as thick as
regular letter paper, which measures about .0035", so it would not
hurt to try Don' suggestion.
My primary hunch, however, is that you need to physically clean the rollers.
>No that's not obvious (to me at least). I did the aligment check on
>regular paper, then printed the neg on Pictorico. I left the paper
>thickness lever at the standard (0) setting, not the + setting.
>Should I be doing the alignment on the Pictorico material??
>>I may be stating the obvious but did you run an alignment check on
>>the Pictorico OHP? Also the the paper thickness lever may need to
This archive was generated by hypermail 2.1.5 : 09/05/03-09:30:46 AM Z CST